Deep Cut Blade for vinyl cut Likart 3 pcs deep cut blades can only be used in the specific black color housing. Our deep cut blades work great for: Maker 3 Maker Explore 3 Explore Air 2 Explore Air/One You can use the black deep cut blade for all Explore family machines and Maker family machines. Safe Comes First This blade is super sharp, for your safety, each blade is covered with a plastic cap that protects both the blade and your fingers! Black Deep Cut Blade Likart 3 pcs deep cut blades can only be used in the specific black color housing. These deep point blades for vinyl cut super smooth and are perfect for detail and small designs. Step 1: Remove the Old Blade Push the pin on the top of the housing and carefully pull out the old blade from the bottom. Step 2: Expose the New Blade You should take care taking off the black rubber cap to expose the knife blade. Step 3: Put in the New Blade Upside down the housing, carefully insert the new blade. Ensuring the blade end is facing outwards. Step 4: Install Blade Housing to Machine Open Clamp B and place blade housing in Clamp B, ensuring that housing is seated on the top surface of the clamp. Close the clamp. Cut Clean & Smoothly Our deep point blades help you cut thicker materials clean and fluently with no dragging and no skipped spots. Our deep cut blade is angled at 60 degrees so that it can slice deeper into a material, our deep cut blades can cut on a wider variety of materials for your projects. Recommended for intricate cuts on thicker materials up to 1.5 mm thickness, like: Craft foamMagnetChipboardStamp materialCereal boxGlitter cardstockLeatherCorrugated paperAluminum foilStiffened felt, foam sheets, cardboard, matboard, poster boards, and some fabrics.